limit mate with solidworks with 2 values

Rather, twist was added during the sweep operation (a total of 6 turns) to quickly and easily generate the spring.įigure 4: Creating key frames for the piston distance mate. It may also be noteworthy to mention a helical path was not used for the sweep path. Not only does this cut down on screen clutter, it helps to keep extra, unnecessary external references from being accidentally created. After creating the initial in-context sweep path sketch, feel free to open the spring in its own window to finish working on it. It also shows what the completed spring looks like after cleaning things up with a couple revolved features. 1” diameter sweep profile.įigure 3: Sweep path and completed spring.įigure 3 shows the sketch used for the sweep profile.

1” construction line creates room for the.

The position of the sweep profile will be the same relative to the end of the sweep path. To rephrase for clarity, consider the position of the sweep profile with relation to the start of the sweep path. This allows room for the sweep to exist so it doesn’t embed itself into the piston. The reason for the construction line is to control where the sweep path ends. 1” construction line on the left is collinear with the line and its left endpoint is coincident with the face of the piston. The right endpoint of the line is coincident with the face of the block. The piston component itself has a distance mate (not shown) which controls how far the piston face is from the face of the block on the right. The ends of the piston (the blocky shapes) have already been mated into position. Looking at Figure 2, we can see the sweep path, which is the most critical part of this demonstration. We will also assume a basic understanding of swept features and using the motion manager to create simple animations. In our example, we will show how a spring can be compressed and uncompressed during the animation sequence.įor the sake of adhering to the topic at hand, and for the sake of brevity, this article assumes you know how to create components in the context of an assembly. Have you ever wondered how to create an animation that included a component that deformed? The technique involves creating a part in the context of an assembly, which you may already know how to do.

Limit mate with solidworks with 2 values